Pathway’s Ribway duct are innovatively designed with straight ribs in inner layer along with super smooth lubricated layer. The ribs are so designed to effectively increase the airflow between the cable and the duct thus reducing contact & friction between the surfaces. Improves installation crew productivity & reduces frequency of placing crews handling cable.
1.
Further reduces contact & friction between the surface thereby increasing longer blowing lengths.
2.
Easy movements of cables at bends
3.
Available with options such as Pre-installed PP/Nylon Rope, Tracer Wire.
4.
Available in wide range of diameter, colours& lengths as per needs & demands of industry.
Pathway’s HelixRibway is a special designed duct manufactured with spiral ribs inside to enhance blowing performance in field. The ribs are formed in a optimum helix angle to create air swirl effect around the cable.
The blowing air moving through the spiral ribs creates air swirl effect around the cable which increases the cable moving speed in the direction of the air flow thereby increasing the blowing speed. The blowing length of cable is increased as the friction drag is reduced comparatively due to less contact of cable with duct. Total number of spiral ribs provided are typically 32 nos.
1.
Longer installation lengths mean longer cable lengths (drums) can be used.
2.
Greater revenues through cost savings of faster-up linking.
3.
Available with options such as Pre-installed PP/Nylon Rope, Tracer Wire.
4.
Available in wide range of diameter, colours& lengths as per needs & demands of industry.
Pathway’s TurboRibway is a advance duct specially designed for improving blowing performance. This duct considerably increases the blowing length and speed of blowing. The specially designed wide spiral ribs with increased spacing increase the air swirl effect created around the cable which carries the cable at higher speed in the direction of the air flow thereby increasing the blowing speed.
The friction drag is reduced considerably and longer blowing length is achieved constantly in blowing. In addition, because the advancing cable is mostly off the ribbing, there is an opportunity for cooling and re-lubrication. Total number of spiral ribs provided range from typical 6 nos.
1.
Longer cable lengths up to 2 times that of standard lubricated duct can be installed by blowing.
2.
Lower stresses on cable.
3.
Greater revenues through cost savings of faster-up linking.
4.
Available with options such as Pre-installed PP/Nylon Rope, Tracer Wire.
5.
Available in wide range of diameter, colours & lengths as per needs & demands of industry.
